Power UNITS FOR LIFT TABLE one
General Description
This power unit is designed exclusively for that smaller lift table,Consisting of substantial stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit has been widely used during the market of logistic products for example minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is controlled from the solenoid valve together with the speed controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Standard Description
This electrical power unit is developed solely to the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve as well as pace managed by the adjustable needle 
valve. When the lift rises to a higher positoin, but the electrical power supply is lower, the reducing movement is managed through the manual override perform.
Energy UNITS FOR LIFT TABLE three
General Description
This electrical power unit is made solely for the massive lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as the pace controlled by a stress compensated movement control valve.
Power UNITS FOR LIFT TABLE four
General Description
This power unit is created exclusively for your big lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve and also the pace managed by the adjustable needle valve. When the lift rises to a large positoin, but the energy supply is reduce, the decreasing motion is managed through the guide override function.
Exclusive Notes
1. This electrical power unit is of S3 duty cycle, which can only get the job done intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all of the hydraulic parts concerned prior to set up of the energy unit.
three. Viscosity with the oil shoud be 15~46 cst,which really should also be clean and no cost of impurities.N46 hydraulic oil is suggested.
four. Oil shifting is needed just after the preliminary 100 operation hrs,afterwards the moment each and every 3000 hrs.
5. The power unit proven is created to be mounted vertically.
