SMR Gearbox Set up
Satisfactory efficiency relies on correct installation. lubrication and servicing. as a result it is vital the directions while in the set up and servicing leaflet. supplied with every single gearbox. are followed cautiously. some of the critical aspects of belt and torque-arm installation are listed beneath.
1. Install pulley on gearbox input shaft as near towards the reducer achievable, and mount reducer on driven shaft as shut to bearing as sensible. failure to perform this may induce extra loads within the input shaft bearings and output bearings and could lead to their premature failure.
2. Install motor and wedge belt drive together with the belt pull at somewhere around 90° to the center line among driven and input shafts. this can permit tensioning of your wedge belt drive with the 
torque arm which need to preferably be in stress. if output hub runs anti-clockwise. torque arm should be positioned the best.
3. lnstall torque-arm fulcrum on a rigid support so that the torque-arm might be at somewhere around ideal angles to your center line with the driven shaft as well as the torque arm situation bolt. ensure that there’s enough consider up from the turnbuckle for belt stress adjustment.
Continue to keep shut.
Bell drive might be positioned in any hassle-free postion. if the torque arm will be to be applied to tighten the belts, the drive ought to be at about tight angle on the line involving the input and output shafts.
Bell drive may be located on the ideal if preferred.
If output hub rotates clock-wise. position belt drive and torque arm in opposite course to that shown inside the illustration.
Torque arm and belt get up.
Torque arm might be mounted to your proper if wanted.
